Digital Meter FAQs

Yes, for a few minutes. You will need to reset electronic clocks and other devices.

With these new meters, Guthrie County REC can read the meter remotely from our central office. Information from the meter is transmitted back to the co-op in daily increments. Transmitting this information electronically means that a meter reader no longer comes to your house in person.

The meter upgrade provides Guthrie County REC members with numerous benefits. The new meters will help us:

• Save money by eliminating the labor and transportation costs of in-person meter reading– a savings we pass on to our members.
• Improve billing accuracy, eliminating misreads or inaccurate readings.
• Pinpoint the exact location of outages more quickly, meaning a faster response time.
• Help our consumer-member troubleshoot high-bill problems by providing information about power consumption patterns, outage and blink count history and voltage information, reducing usage questions.
• Improve electric service reliability and power quality – fewer outages, blinks and surges.
• Help secure the overall safety of the cooperative employee team.

There will be no additional costs to the member to install the new system. There is no rate increase anticipated in association with this project. Following the installation, members will receive a bill with two readings:  one for the old meter and one for the new meter.

No additional parts are anticipated or required. However, if something is identified as faulty or hazardous with member’s equipment, the co-op will replace it.

Guthrie County REC employees and our meter contractor WESCO/ANIXTER.

No. New meters will be installed on all accounts. The cooperative is embarking on a system-wide program that will change 100 percent of existing residential and commercial meters in order to acquire more accurate information, without the need to enter a member’s property.

With the new system, customer service representatives can access the meter information and obtain the reading almost instantaneously.

The new system will give the cooperative daily meter readings, instead of monthly readings. Other features of the new system will provide new data that will enable us to monitor the system better and correct inefficiencies.

The new meters are digital electronic devices while the old meters were an electro-mechanical device. The new meters will continue to display the meter reading, but it will be in a digital LED format. The biggest difference is that the new meters will have an electronic circuit board module installed. The module receives and stores the kilo-watt-hour (kWh) and demand consumption recorded by the electronics in the meter, and is able to transmit securely this and other system data back to the cooperative’s computers.

Yes, members will continue to stay on the same rate class as they have in the past.  There will be no increased cost to the member.

Contact the co-op office right away to discuss your billing concerns. Electronic meters are more accurate than analog or mechanical meters. The new meters installed have been tested and meet American National Standards Institute (ANSI) regulations. 

The new meters allow for accurate readings and a consistent billing period.

The new meter records an electronic kWh reading, the date and time of energy usage, the overall peak demand of the electric account, if the meter has rotated backwards, and the number of times the meter has experienced a loss of power for any reason. In fact, the meter will record the date and time of light blinks and the length of the power outage.

All of the co-op’s new meters can be read at a variety of times to obtain a history of account information. However, for billing purposes member bills will be read on monthly schedules.

No. Reasonable access to equipment still must be maintained. This allows for cooperative personnel to either read or maintain the meter if necessary at reasonable times.

The cooperative’s automated metering system will communicate with the substation-installed equipment, which sends a request for one or more meter readings. The meter reading is sent back to the co-op via a secure network.

No. Research conducted by the Electric Power Research Institute, the Utilities Telecom Council and others has revealed no health impacts from digital meters. The radio frequencies emitted by digital meters falls well below the maximum recommended in federal guidelines. Contrary to some misconceptions, the new meters emit radio frequencies (RF) only when responding to a request for data from the co-op office – either once every fifteen minutes or once every hour for less than a second.  Compare this activity to a laptop with a wireless connection, which is constantly sending and retrieving data. A digital meter equipped to send and receive data has an RF density hundreds of times less than the RF density of a cell phones – and the meters are installed on the outside of your house not next to your ear!

Routine inspections of all meters and services will continue in order to look for safety hazards, theft or other problems.

The meter display is visible for members to be able to check their consumption. All other information and data stored in the meter is secure and the meter is sealed.

Yes, meters have remote disconnect and reconnect capabilities.

Yes. The meters will be able to record outages allowing the cooperative to verify whether the outage is either on the member’s side of the meter or the co-op's.

Yes. We posted an installation notice in our April newsletter, Iowa Electric Cooperative Living. You can check for updates on our website and the cooperative Facebook page.

The co-op employee or contractor will knock on your front door to let you know they need to change the meter. We will work with businesses to minimize any inconvenience. You do not have to be present during the meter change. There will be a short interruption of service for the meter exchange.